![]() ![]() script file and it opens in Script Editor and does nothing. (I suspect because it needs to run as Sudo, but I don’t know how to load it with sudo.) (these are divided with spaces, not hard returns.)Īfter successfully booting into 1920x1080 accelerated HD3000 graphics, I ran the Post Repair bash script in Terminal (right click open with.) it fails. ![]() v -no_compat_check amfi_get_out_of_my_way=0x1 amfi_allow_any_signature=0x1 cs_enforcement_disable=0x1 Was able to boot successfully with long argument string: Peter, where are the boot arguments discussed? How did you learn about them? I saw your general description AMFI link, but does the patch author discuss this issue offsite? Do you have a link? I searched for and found this same thread and Peterhack’s posts. Waited forever, but it nudges along until full and then just sits there.īooted Verbose to see what was going on, see an endlessly repeating AMFI error. (Where is the documentation for this process? Or are the Pre and Post scripts just automatically built into the Package installer?)Īfter installing the package and rebooting, I get a slow boot progress bar at 2/3 completion. Didn’t know to run any Pre or Post scripts. Was eventually able to reboot successfully repeatedly with 1024x768 resolution.īuilt the Legacy-Video-patch-16 package (watch the video) and installed it successfully. Building a CustoMac Hackintosh: Buyer's GuideĪfter installing 10.15.2 from Unibeast, I did the rough update to 10.15.4 under Clover 5102.
0 Comments
Leave a Reply. |